POOLDOCTOR2104
Newbie
Posts: 1
Registered: 11-4-11
Member Is Offline
|
posted on 16-11-11 at 06:30 AM |
|
|
Skimmer replacement
We are expanding our leak repair department and would like someone to share with us the tricks to doing skimmer replacements. We'll send you a
couple of gift cards for your time. Please contact me at Mark@MyPoolDoctor.com
|
|
Semi_Retired
Junior Member

Posts: 68
Registered: 22-7-11
Member Is Offline
|
posted on 16-11-11 at 09:46 AM |
|
|
On which kind of pool? Concrete, vinyl liner, or fiberglass?
|
|
Poolman
Member
 
Posts: 101
Registered: 13-4-06
Member Is Offline
|
posted on 21-12-11 at 12:55 PM |
|
|
If we are going to do skimmer replacement in a liner pool;
Lower the water to 4-5" below the skimmer. Get a lump of 8x2 and cut out a notch that is appx 4" up the side of the skimmer and all the way along.
Screw this to the wall through the liner, pool side. This stops any debris from dropping behind the liner as you take the old skimmer out and keeps
the liner in position. I guess you could batten through the liner around the skimmer position, I like a large lump as it only needs a few fixings,
less holes to repair after. You need to leave enough space to remove and replace the face plate. If worse comes to worse you can always stick a new
bit of liner on the old.
|
|
4Leakman
Member
 
Posts: 152
Registered: 27-6-06
Member Is Offline
|
posted on 23-12-11 at 03:04 PM |
|
|
???
What is 8x2 ???
|
|
Poolman
Member
 
Posts: 101
Registered: 13-4-06
Member Is Offline
|
posted on 26-12-11 at 02:23 PM |
|
|
timber, 8 x 2 inches
|
|
cpr
Junior Member

Posts: 12
Registered: 10-3-08
Member Is Offline
|
posted on 27-12-11 at 09:06 AM |
|
|
r U replacing skimmers in gunite pools? If so I can give you a few tips and tricks. My average skimmer replacement is 6 hrs from start to finished
including loading and unloading all tools and patching decks and that is doing it by myself. I have done them in less time and have had them out of
the ground in less than an hour.
|
|